Match the remote control address with the controller
First: After the controller joins RGB LED product, on the electricity, presses the “POWER” key, the controller output closure.
Second: Press the “Pause” key, the controller output will be in the red light to show it have been in the state of indentifying the address.
Third: Press any key of the remote controller, the controller output will be in the green light to show it has received the signal of controller.
Fourth: Press the power key to test whether the set is ok, if not please try again,
The Function description of the key
Color pulley: Sliding a finger on the color pulley to choose a receptor output color of 64 colors choice. (The correct way of operation: clockwise sliding your finger on the color pulley)
Function keys: MODE+, MODE-Mode selection
SPEED+, SPEED- Speed selection
BRT+, BRT- Brightness selection
Group control (one remote controller can control several controllers)
When the remote is on the state of active, pressing key 1-9 then the”#” can change the remote’s address code.(For example, Once pressing 1,#,the address code of remote is 1;if pressing 1,3,#,the address code will change to 13.)
Application examples: a remote control A, B, C, D four receptors
First, please set a different address respectively for receptor A, B, C, D according to the step of “pair address of receptors and remotes”. (For example, set receptor A to 1, receptor B to 2, receptor C to 3 and receptor D to 4. The address can be set to a 1-digit or 2-digit optionally, but you must remember it. Please set the address again if you forget.)
Second, when the receptor and remote are paired up, you can press digital key 1, then the key “#” to control the receptor A (Because the address of receptor A has been set to 1 when you pairing the address of receptors and remotes). Pressing digital key 2, then “#” is to control the receptor B, and you can control other receptors like that. Only when you switch between different receptors will need to reset the address of the remote to match the receptor. The remote will save the last address when the power is turned off.